AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
How to install smexoscope max2/2/2023 I am looking for peaks, dynamics, max and min volumes. I turn this up until a little clipping occurs.Ī Utility that I switch to mono to check for phase problems.ġ - Nu Gen Visualiser used as a level meter.Ģ - Fast Spectrum analyser to look for peaks that may cause clipping.ģ - s(M)exoscope Waveform visualisation so I can watch the waveforms. The most important part is a hard Limiter set to -0.3 dB which I use as a gain control so I can get a decent volume without too much clipping. It works on some tracks not on others, so use with care. Its a very light compression but can gel the mix together. Remove this for composing as it causes a delay.Ī final mastering equaliser for some gentle boosts and cuts. On my master bus I put a FabFilter Pro-Q set to 48db/Oct slope, at 22Hz and 19KHz to remove inaudible frequence, set to Linear Phase.
0 Comments
Read More
Leave a Reply. |